Changing the Clutch and Cord Loop on the Continuous Cord DO NOT lay the shade down while doing this. Gently advance the teeth of the sprocket using a screw driver or other blunt object. Let the shade down an inch or two. Gently advance the teeth of the sprocket using a screw driver or other blunt object.
Remove old cord loop from teeth of the pulley. Place new cord loop into teeth. While using a screw driver or blunt end object move the pulley teeth around with the
cord. The cord loop should be exiting the guide so that the loop is towards the front of the shade assembly. Gently reinstall clutch cap. Insert top hooks of cap into clutch, hinge cap down,
and snap bottom tab into place. Let the shade down completely then close it again. | 
